Homeowner Maintenance Manual

S E C T I O N 3 — C E N T U R Y H OM E C O N N E C T

Home Automaton Light Switches

Dimmer

Go to Section Start Go to Index Go to Table of Contents

All home automation light switches are paddle style and can be identified by a steady or blinking blue LED light. All builder installed switches or dimmers, are Z-Wave enabled and can be controlled: • Manually just like a non-automated rocker or toggle switch, • Remotely through your smart device when paired through the Nexia home automation hub, or • By voice, via a voice assistant such as Google Assistant. Your switches, or dimmers, are S2 certified, an enhanced wireless encryption and cyber security protocol that deters hacking. If you want to disable the blue LED light, it can be dimmed or turned off completely. Refer to the manufacturer’s instructions outlined here: • Release the paddle. In a few seconds the blinking will stop. At this point, the blue LED will be on bright when the switch is turned ON, it will be on dim when the switch is turned OFF. To change the intensity of the blue LEDs once the blinking has stopped or to change the LED when the switch is in the “OFF” position: • Turn the switch OFF. • Press and hold the paddle down for 15 seconds until the LED begins to blink. • Tap the paddle slowly to change the LED intensity. • This change will happen real time. • When the desired intensity is reached, double tap the paddle. One of the levels of brightness is actually off. To change the “ON” LED: • Repeat the above process with the switch in the ON position. • Press and hold the switch paddle down for a full 20 seconds. • The LEDs on the device will begin to blink VERY rapidly.

C E N T U R Y C OMM U N I T I E S

PA G E 3 . 3